Modeling With Pro/Engineer Wildfire 30

This book synergistically integrates the design process with the specific commands and procedures of Pro ENGINEER through a unique presentation scheme. Users are first provided with the design information about the part or assembly and its design intent. Then, they see the sequence of steps involved in modeling the part/assembly. Detailed instructions are provided in a four-column presentation showing goals, steps and commands. The consistent approach is supplemented by many illustrations on each page. Each chapter adds new information while reinforcing key concepts. Table of Contents 1. Introduction 2. Bearings 3. Bearings 4. Bushing 5. Retaining Ring 6. Shaft 7. Shaft Drawing 8. Nuts and Bolts 9. Radial Plate Cam 10. Housing 11. Cam Assembly 12. Cam Follower Assembly 13. Washington Monument and Wing 14. Gateway Arch 15. Springs 16. Spur and Helical Gears 17. Axial Cam 18. Grooved Cam 19. Bolt Heads 20. Electrical Fuse AssemblyCondoor, Sridhar is the author of 'Modeling With Pro/Engineer Wildfire 30 ', published 2006 under ISBN 9781585033119 and ISBN 1585033111.